• +8618025978448
  • info@gordakelec.com
× 发送

二合一返修工作站的常见问题及解决方法

A 2-in-1 soldering and hot air rework station is a versatile tool that streamlines your electronics repair work. However, even high-quality units can experience issues over time due to frequent use, poor maintenance, or incorrect operation.

This guide covers the most common problems with 2-in-1 rework stations, along with practical solutions to keep your equipment in top condition.

GORDAK 968D Soldering And Rework Station

Cause:

  • Burned-out heating element
  • Loose or broken wiring inside the handle
  • Faulty temperature control circuit

Solution:

  • Check the iron’s power cable and connector
  • Test the heating element for continuity and replace if faulty
  • If wiring is intact, the control board may need repair or replacement

Tip: Always use original Gordak spare parts for reliable performance.

Cause:

  • Clogged nozzle or air intake
  • Faulty air pump or turbine
  • Damaged air hose

Solution:

  • Clean the nozzle and air filter with a soft brush or compressed air
  • Ensure the air hose is not pinched or blocked
  • If the pump is noisy or non-functional, it may need to be replaced

Cause:

  • Sensor drift due to prolonged use
  • Faulty thermocouple or control board
  • Calibration error

Solution:

  • Use a thermometer to verify actual temperature
  • Replace the thermocouple if it’s providing false readings
  • Recalibrate your station if supported by your model

Cause:

  • Loose internal wiring or poor solder joints
  • Power supply instability
  • Overheating protection kicking in

Solution:

  • Inspect internal connections if you’re trained to open the unit safely
  • Avoid sharing the power outlet with high-drain devices
  • Ensure proper ventilation around the station to avoid overheating

Cause:

  • Excessive temperature settings
  • Blocked airflow causing heat buildup
  • Defective thermostat or sensor

Solution:

  • Operate within recommended temperature ranges (typically 200–450°C)
  • Keep the airflow unblocked and check the fan/pump
  • Replace the sensor if it fails to regulate heat properly

Cause:

  • Blown fuse or faulty power supply
  • Faulty power switch
  • Burned circuit board components

Solution:

  • Check and replace the fuse if necessary
  • Inspect the power cord and switch
  • If no visible damage, consult a technician or the manufacturer

Cause:

  • Excessive temperature use
  • Lack of tip cleaning and tinning
  • Poor-quality solder

Solution:

  • Use appropriate soldering temperatures (300–350°C for most jobs)
  • Clean the tip with brass wool and tin it after each use
  • Use high-quality, lead-free solder with flux

Many issues with 2-in-1 rework stations can be prevented with routine care. Refer to our Maintenance Guide for best practices.

Gordak Double Digital Soldering And Rework Station 868D

At Gordak, we manufacture durable and affordable 2-in-1 rework stations, offering factory-direct pricing for dealers and workshops. Our products are designed for precision, safety, and longevity — supported by our responsive technical service.

For inquiries or bulk orders, email info@gordakelec.com.

请在浏览器中启用JavaScript来完成此表单。